Wireless room unit - MIDAM WRU01001
Wireless, battery powered HMI unit. The device features temperature and humidity sensors, the values of which can be displayed to user on a large LCD display. Native modbus map grants seamless integration into the SCADA system. The communication is based on the AES128 encrypted Midam KFP protocol, which allows to update the device firmware on a wireless basis.
- Temperature sensor
- Humidity sensor
- LCD display
- Battery power supply
- Wireless transmission
- SCADA integration
Temperature 
Humidity 
Wireless Function
The WRU01001wireless room unit measures temperature and relative humidity. It allows to set the desired temperature setpoint and operating modes using the rotating knob. The values are transmitted through the 868 MHz unlicensed band to the WCOM51, or WCOM01 gateways. Embedded AES 128-bit, provides the most secure encryption standard for wireless connections. There is also an option without rotating knob and display available ( refer to WRU01009 room sensor ) to provide a variety of possibilities for building up a project. In asynchronous mode and upon direct pairing with one of the wireless modules for lights and blinds WOUT2x1, it is possible to use the room controller for direct control according to the set value (setpoint with hysteresis). The device has factory-set values to ensure the correct default function and allows direct reading and writing of values to the Modbus map, which is available in a separate document. All settings are also stored in the Modbus map directly in the device. Before using the device for the first time, it is necessary to pair it and it is recommended to perform individual configuration, especially to change the encryption password.
Application
- HVAC control
- Measurement of temperature and humidity
- Display of status values
- Wireless integration into SCADA control systems
Pairing
Two devices are required for mutual communication. Both must be powered and located in close proximity to each other. Usually, wireless gateway or configuration dongle (WUSB01)is used to set up remote wireless devices. Use look-up function in software tool to display a list of all available devices in range and assign or adjust parameters based on wireless ID code for each single device. There is a comprehensive help section integrated in the software tool to provide support during the wireless device set up procedure.
SCADA system integration
The controller can be integrated into DDC or SCADA systems directly via the WCOM51, WCOM01 wireless gateways or fancoil controller WFC01001 respectively.
Midam KFP Password change
Prior to the first use, the encryption password (default “MIKROKLIMA1234AB”) must be changed using the WUSB01 configuration dongle and the relevant software tool.