Wireless temperature sensor with magnetic probe - MIDAM WBBS09
Wireless, battery powered temperature sensor with magnetic probe providing easy snap on function to M8 socket screw in so called BUSBAR electrical cabinets. Native modbus map grants seamless integration into the DDC/SCADA system. The communication is based on the AES128 encrypted Midam KFP protocol, which allows to update the device firmware on a wireless basis.
- Temperature sensor with magnetic probe
- Native modbus map
- Wireless transmission
- Battery power supply
- SCADA integration
Function
The wireless temperature sensor WBBS09 measures temperature in non-aggressive environments using the magnetic probe situated outside the device body. The values are transmitted through the 868 MHz unlicensed band to the WCOM51, or WCOM01 gateways. Embedded AES 128-bit, provides the most secure encryption standard for wireless connections. The device has factory-set values to ensure the correct default function and allows direct reading and writing of values to the Modbus map, which is available in a separate document. All settings are also stored in the Modbus map directly in the device. Before using the device for the first time, it is necessary to pair it and it is recommended to perform individual configuration, especially to change the encryption password.
Application
- Monitoring of Electrical Distribution Cabinets
- Temperature Measurement
- Wireless Integration into SCADA Control Systems
Pairing
Two devices are required for mutual communication. Both must be powered and located in close proximity to each other. Usually, wireless gateway or configuration dongle is used to set up remote wireless devices. Use look-up function in software tool to display a list of all available devices in range and assign or adjust parameters based on wireless ID code for each single device. There is a comprehensive help section integrated in the software tool to provide support during the wireless device set up procedure.
SCADA system integration
The sensor can be integrated into DDC or SCADA systems directly via the WCOM51, or WCOM01 wireless gateways.
Midam KFP Password change
Prior to the first use, the encryption password (default “MIKROKLIMA1234AB”) must be changed using the WUSB01 configuration dongle and the relevant software tool.